[SUPERFLY] TURBOCHARGED BUTTERFLY REPLACEMENT BOOTLOADER

AUTHOR: RETRODAN

Turn Your Butterfly into a SUPERFLY Speed Demon by adding a 4-Speed Transmission and a Turbo Charger!

Due to Lock-Up problem with Butterfly Booter it is recommended that it be replaced. Try replacing it with SUPERFLY or SUPERFLEA.

Use Joystick to select Speeds of 1, 2, 4 or 8 Mhz.

MAIN FEATURES:

a) SMALLER: Only 378 words (Atmel Original is 1500+)
b) SECURE - Can't accidentally alter fuse/lockbits - No LOCKOUTS
c) SAFER - Extra Warning - No Accidental Over-Writes
d) FASTER - Joystick Up Launch programs at Turbo (High) Speed
e) FLEXABLE - Joystick Down at Original (2MHz) Speed
f) ADDITIONAL- Joystick Left goes Mid-Speed (4Mhz)
g) VARIETY- Joystick Right is Slow Speed (1Mhz)
h) FASTER - Programs Upload Quicker
i) EFFICIENT - Conserves Battery with "Sleep Mode"
j) EASIER Stack set-up, no need to do it in your program.
i) ROOMIER - More program space for your Applications
k) CONVIENIENT - Don't waste code on speed selection
l) SIMPLE - Works as original, no additional docs reqd

FREE for personal, educational, non-commercial applications. All rights reserved.


I can't get Lock-Up or Failure from either of these and no has reported a single one to date. If you do, let us know ASAP.

Say SUPERFLY sounds very cool but can install it using my currently installed boot loader using AVR Studio or do I need to load/install it some other way?

The BootLoader you have now, that uses the Serial Port will not allow itself to be overwritten, so you need to use a parallel-port programmer or something like the STK500 to reprogram it.

Is that what you were asking? If the Bootloader that uses the AVR Prog and the serial port can be used to install a new bootloader?

Yes, that is what I was asking. Thanks!!